本經驗適用于以下兩種情況：

1、系統自動自檢完畢，剛進入進入windows讀條狀態，即彈出下圖內容，時間不足一秒，然后又進入重啟、自檢狀態，如此反復（WindowsXP較常見）；

2、系統啟動中，出現藍屏（WIN7較常見）

圖中文字內容：
A problem has been detected and windows has been shut down to prevent damage to your computer. If this id the first time you've seen this stop error screen,restart your computer. If thid screen appeas again,follow thiese steps: check for viruses on your computer. Remove any newly installed hard drives or hard drive controllers. check your hard drive to make sure it is properly configured and terminated.Run CHKDSK /F to check for hard drive corruption,and then restart your computer. Technical information: ***stop:0X000007B(0XF7B55524,OXC0000034,0X00000000,0X00000000)

步驟/方法

啟動系統，進行BIOS，在BIOS的System相關選項里，將AHCI改為ATA或其它選項即可，保存設置，重新啟動計算機。

注意事項

• 僅用于WindowsXP/Win7系統